Link Hall Effect Sensor Kit

Link Hall Effect Sensor KitHall Effect Sensor Kit Part Number: 101 0280 Hall effect sensor designed for use in applications where ferrous edge detection near zero speed sensing is needed. They provide a sinking current output. Typical automotive applications include: Crank & Cam Signals Speedometers Anti lock braking systems Box Contents 1 x Hall Effect Sensor 1 x DTM3 Connector Kit Set (Matching set, Male & Female connectors, pins & wedges) Features: From near zero speed up to

Part Number: 101-0280

Hall effect sensor designed for use in applications where ferrous edge detection/near zero speed sensing is needed. They provide a sinking current output. Typical automotive applications include: Crank & Cam Signals Speedometers Anti-lock braking systems Box Contents 1 x Hall Effect Sensor 1 x DTM3 Connector Kit Set (Matching set, Male & Female connectors, pins & wedges)

Features: From near zero speed up to 15 kHz sensing capability
10 bit dynamic threshold direction offers: Automatically adjusting magnetic range, Self-compensating to target geometry
Compatible with unregulated power supply
RoHS compliant
IP67
Typical air gap of 1.5 mm

Specifications: Thread = M12x1.0
Lead Length = 1m (20 AWG)
Pin Out:
Brown = Supply VCC
Blue = Ground
Black = Output V
Voltage = 5v - 24v
Max Current Draw = 6 mA
Maximum Speed Detection = 15 kHz
Maximum Installation Torque Limit = 5.65 Nm (50 in lb) on thread
Recommended External Pull-Up Resistor:
5 Volts DC = 1k Ohms
9 Volts DC = 1.8k Ohms
12 Volts DC = 2.4k Ohms
15 Volts DC = 3k Ohms
24 Volts DC = 3k Ohms
Operating Supply Voltage = 5 to 24 VDC
Maximum Input Voltage = 30 VDC
Maximum Reverse Voltage = 24 VDC
Supply Current = 3 mA typ., 6 mA max
Output Sink Current = 20 mA max
Housing Material = Anodized Aluminum
Operating Temperature = -40 °C to 125 ͼC
Ingress Protection = IP67
Sensor Length = 65.5mm (2.58 inches)

For best results, we recommend targets made from low carbon cold rolled
steel. Other factors that influence sensor performance include gear tooth
height and width, space between the teeth, shape of the teeth and thickness
of the target. As a general guideline, consider a target with minimum
parameters as shown below. Note that smaller dimensions may work, but
testing for the application is required.

Tooth Height - 5.0 mm (.200")
Tooth Width - 2.5 mm (.100")
Distance between
Teeth - 10 mm (.400")
Target Thickness - 6.35 mm (.250")